Introduction

The Water Treatment Flocculant's main component is polyacrylamide abbreviated as PAM, which is a linear polymer and a water-soluble polymer compound with wide application. It is generally used to remove or reduce turbidity or suspended matter in water, to produce large particles of cohesion, and to speed up the settling of impurities and sludge in water. The Water Treatment Flocculant can be widely used in water treatment, paper making, petroleum, spinning and other industrial sectors.

Product Feature

1. The Water Treatment Flocculant can neutralize suspended matter, bridging adsorption and flocculation by electricity.

2. Adhesiveness: It can be used for adhesion by mechanical, physical and chemical action.

3. Resistance Reduction: It can effectively reduce the frictional resistance of fluid, and can reduce the resistance by 50-80%.

4. Thickening: It has a thickening effect in neutral and acidic conditions. When the PH value is greater than 10, PAM is easy to hydrolyze and thicken more obviously.

Usage methods and precautions

1. 0.2% aqueous solution is suitable for actual neutral salt-free water.

2. Due to the wide range of application of this product, the general dosage is 0.1-10ppm (0.1-10mg/L).

3. Dissolve completely. Dissolution requires full stirring of the water body, then slowly and evenly add the powder to prevent blockage of pipes and pumps caused by large flocs and fish eyes.

4. The stirring speed is generally 200 rpm and the time is not less than 60 minutes. Properly increase the water temperature by 20-30℃ to accelerate the dissolution, but the maximum temperature of the medicine solution should not exceed 60 degrees.

5. Determine the best dose. Determine the best dose by experiment before use. If the dose is too low, it will not work, and if the dose is too high, it will cause side effects. When the concentration exceeds a certain concentration, PAM will not flocculate, but disperse and stabilize the use.

6. This product should be stored in a cool and dry place to prevent moisture.

7. The workplace should be flushed with water frequently to keep it clean. Dispersed PAM has a smooth surface when it meets water due to its high viscosity, which prevents the operator from slipping and causing safety accidents.

http://www.oubochemical.com/